Thingiverse
arm cuff
von AdamKnight
2
Downloads
0
Likes
0
Makes
arm cuff.
For the joint use a bit of 1.75mm fillment and melt the ends to make them flat. (do not weld them to the body). the ends will go black but if you sand them it will remove the black and be the right colour.
For the clamps on the sides you could use filiment or i think a paper clip will work.
For the joint use a bit of 1.75mm fillment and melt the ends to make them flat. (do not weld them to the body). the ends will go black but if you sand them it will remove the black and be the right colour.
For the clamps on the sides you could use filiment or i think a paper clip will work.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!