Thingiverse
ASK13
von florianblanc
96
Downloads
93
Likes
2
Makes
This is a *static model* of the popular training glider ASK13. The model comes in two ready to use bluid plate. If the outer wing part is too difficult to print straight up, it might be a good idea to print it flat.
Printed just fine on my Ender 3 with 0.16mm PLA layers, after a slicing done with PusaSlicer.
No raft or brim used, these would probably be a pain to remove ^^
You may also want to check my full collection: [ASK-13](https://www.thingiverse.com/thing:4840767), my [Br905 Fauvette](https://www.thingiverse.com/thing:5166426), my [JS3](https://www.thingiverse.com/thing:5138871), [Janus C](https://www.thingiverse.com/thing:4824557), [Libelle H205](https://www.thingiverse.com/thing:5419202), [Horten IVa](https://www.thingiverse.com/thing:6230518) and my [Ka6e](https://www.thingiverse.com/thing:4948591).
*Finishing*
- Basic finishing can be done with just acrylic paint applied with a brush or even using a felt pen.
- For a pro finish I use the following:
- Rough
Printed just fine on my Ender 3 with 0.16mm PLA layers, after a slicing done with PusaSlicer.
No raft or brim used, these would probably be a pain to remove ^^
You may also want to check my full collection: [ASK-13](https://www.thingiverse.com/thing:4840767), my [Br905 Fauvette](https://www.thingiverse.com/thing:5166426), my [JS3](https://www.thingiverse.com/thing:5138871), [Janus C](https://www.thingiverse.com/thing:4824557), [Libelle H205](https://www.thingiverse.com/thing:5419202), [Horten IVa](https://www.thingiverse.com/thing:6230518) and my [Ka6e](https://www.thingiverse.com/thing:4948591).
*Finishing*
- Basic finishing can be done with just acrylic paint applied with a brush or even using a felt pen.
- For a pro finish I use the following:
- Rough
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
