Thingiverse
Atari ST foot
von Dreido
7
Downloads
3
Likes
0
Makes
Just a little foot for the Atari ST since one of them completely degraded.
It's probably best printed in a flexible material like TPU for grip, but PLA works to keep the Atari level.
It should just snap in place with a push, no glue needed.
It's probably best printed in a flexible material like TPU for grip, but PLA works to keep the Atari level.
It should just snap in place with a push, no glue needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
