Thingiverse
Atibal STD guard
by emcon_delta
2
Downloads
1
Likes
0
Makes
Did you buy a Spina closed emitter/Griffin Micro/Atibal STD/SRD and want a kill-flash for it? Now you can get one from the comfort of your own home!
This model uses the windage/battery compartment housing as the index point for a snap-to-fit retention. Because of the tolerances required to utilized this, the following warnings apply:
1. REMOVE THE BATTERY COVER BEFORE ATTACHING TO YOUR OPTIC. FAILURE TO DO SO RISKS BREAKING YOUR PRINT.
2. Once installed, removal of the kill-flash will most likely destroy its ability to reattach securely, and will require printing another. Install only when ready for semi-permanent use, and remove only when deemed absolutely necessary.
Printing in a less-rigid material may impact its ability to stay securely on the optic, though it may result in ease of non-destructive removal and reattachment.
This model uses the windage/battery compartment housing as the index point for a snap-to-fit retention. Because of the tolerances required to utilized this, the following warnings apply:
1. REMOVE THE BATTERY COVER BEFORE ATTACHING TO YOUR OPTIC. FAILURE TO DO SO RISKS BREAKING YOUR PRINT.
2. Once installed, removal of the kill-flash will most likely destroy its ability to reattach securely, and will require printing another. Install only when ready for semi-permanent use, and remove only when deemed absolutely necessary.
Printing in a less-rigid material may impact its ability to stay securely on the optic, though it may result in ease of non-destructive removal and reattachment.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!