Thingiverse
Atom Echo Voice Assistant Base
von jmtodaro
7
Downloads
4
Likes
0
Makes
A minimalist base for the [m5stack Atom Echo](https://shop.m5stack.com/products/atom-echo-smart-speaker-dev-kit). This was created to keep the Echo a bit more stationary for [voice assistant](https://www.home-assistant.io/voice_control/thirteen-usd-voice-remote/) use.
**Important:** Make sure "Print Thin Walls" *(or your slicing software's equivalent)* is enabled.
Print with higher infill for added weight, and it is highly recommended to add non-slip pads to the bottom. The pads alone work well enough for my use case at 10%*(!)* infill.
I print this face down (with supports on the inner recessed lip only) for a better top finish. The little notches do not need support.
**Important:** Make sure "Print Thin Walls" *(or your slicing software's equivalent)* is enabled.
Print with higher infill for added weight, and it is highly recommended to add non-slip pads to the bottom. The pads alone work well enough for my use case at 10%*(!)* infill.
I print this face down (with supports on the inner recessed lip only) for a better top finish. The little notches do not need support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
