Atomic

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.3mm Filaments Used: PLA BambuLab Basic Orange Transmission Distance: 7 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 4 unique filaments. Substitute as needed. Swap Instructions: Start with Orange At layer #9 (0.8mm) swap to Yellow At layer #14 (1.2mm) swap to Black At layer #20 (1.68mm) swap to Jade White for the rest. Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!