Thingiverse
Atomstack A20 Focus alignment guide
9
Downloads
4
Likes
0
Makes
With this alignment tool it is possible to align workpieces with 0mm or 1mm offset to the laser focuspoint. The Atomstack laser head has a size of 63mm x 58mm.
Preparation:
1 Draw a frame in Lightburn the size of the workpiece (T1 or T2).
2 Place the graphic.
3 Position the laser at the bottom left (Frame).
4 Place the alignment aid against the laser head.
5 Place the workpiece on the alignment aid.
6 Remove the alignment aid.
7 Fire
Preparation:
1 Draw a frame in Lightburn the size of the workpiece (T1 or T2).
2 Place the graphic.
3 Position the laser at the bottom left (Frame).
4 Place the alignment aid against the laser head.
5 Place the workpiece on the alignment aid.
6 Remove the alignment aid.
7 Fire
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
