Thingiverse
Atomstack A20 Focus alignment guide
door CordierEngineering
9
Downloads
4
Likes
0
Makes
With this alignment tool it is possible to align workpieces with 0mm or 1mm offset to the laser focuspoint. The Atomstack laser head has a size of 63mm x 58mm.
Preparation:
1 Draw a frame in Lightburn the size of the workpiece (T1 or T2).
2 Place the graphic.
3 Position the laser at the bottom left (Frame).
4 Place the alignment aid against the laser head.
5 Place the workpiece on the alignment aid.
6 Remove the alignment aid.
7 Fire
Preparation:
1 Draw a frame in Lightburn the size of the workpiece (T1 or T2).
2 Place the graphic.
3 Position the laser at the bottom left (Frame).
4 Place the alignment aid against the laser head.
5 Place the workpiece on the alignment aid.
6 Remove the alignment aid.
7 Fire
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
