Thingiverse
Atomstack keychain (fidget toy)
by EliA06
1
Downloads
5
Likes
0
Makes
A stylish, functional fidget toy that you can carry anywhere. Like a gyroscope you can spin the individual rings and disks to unstress your mind.
When printing:
Laying flat on the bed
No supports
No raft
3 shells
Any infill, but for good endurance (at least 8% infill)
*The three ring variation, I added manual supports for the outer rings to prevent the pin from being fully connected to the rings. Remove those and have fun*
After printing:
At first, it will seem like it is stuck or a tight fit. Just keep rotating and in a short amount of time the pins will spin without any trouble. I hope you enjoy my design.
When printing:
Laying flat on the bed
No supports
No raft
3 shells
Any infill, but for good endurance (at least 8% infill)
*The three ring variation, I added manual supports for the outer rings to prevent the pin from being fully connected to the rings. Remove those and have fun*
After printing:
At first, it will seem like it is stuck or a tight fit. Just keep rotating and in a short amount of time the pins will spin without any trouble. I hope you enjoy my design.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!