Attachment Layers
door Oggie
2
Downloads
1
Likes
0
Makes
These attachment layers (ALs) assist in holding prints on your build plate when using an SLA printer.
The Ameralabs article below escribes the benefits of using attachment layers.
https://ameralabs.com/blog/tutorials/attachment-layer-need-know/?fbclid=IwAR3it7w3CuRPVkAJWVnve4oaMUj83q94EC7AXdz5YPIVwuVLncZ68EqTOUA
To use place your stls on the print bed in your slicer and then load an attachment Layer corresponding to the size of your stl underneath. It get absorbed into you print and break off after cure.
Also put them under supports instead of skates.
these are .2 mm, if you want them thinner alter the z height of them in your slicer.
Use multiple ALs, copy them and overlay them for any shape you want.
Bear in mind if printing without supports these will give you a flat surface. If you have form or engraving on the bottom, punch holes in the ALs.
The Ameralabs article below escribes the benefits of using attachment layers.
https://ameralabs.com/blog/tutorials/attachment-layer-need-know/?fbclid=IwAR3it7w3CuRPVkAJWVnve4oaMUj83q94EC7AXdz5YPIVwuVLncZ68EqTOUA
To use place your stls on the print bed in your slicer and then load an attachment Layer corresponding to the size of your stl underneath. It get absorbed into you print and break off after cure.
Also put them under supports instead of skates.
these are .2 mm, if you want them thinner alter the z height of them in your slicer.
Use multiple ALs, copy them and overlay them for any shape you want.
Bear in mind if printing without supports these will give you a flat surface. If you have form or engraving on the bottom, punch holes in the ALs.
Oggie publiceert ook op
16 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
