Thingiverse
Engineering
Model downloaden
Auto locking quick release
10
Downloads
5
Likes
0
Makes
A mechanism that automatically locks onto a 6mm pin and releases easily with a pull or push on a lever.
For safety reasons don't us it for handling dangerous loads.
Install springs or rubber band as shown in image. Then gently hammer it together with a hammer. You can expand the holes in hook, arms and shackle with a 6mm and 4mm drill, if they don't fit. Sharpen corners of level arms at contact point with a file if they are not sharp 90 degree.
For safety reasons don't us it for handling dangerous loads.
Install springs or rubber band as shown in image. Then gently hammer it together with a hammer. You can expand the holes in hook, arms and shackle with a 6mm and 4mm drill, if they don't fit. Sharpen corners of level arms at contact point with a file if they are not sharp 90 degree.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
