Thingiverse
Automatic Trash Can Hinge Fix
von jesse
8
Downloads
9
Likes
0
Makes
These are replacement hinges to replace some that broke on an automatic open/close garbage can. I cracked off the hinge stubs using pliers and shaved down to a flat surface with a razer. The replacement hinges have a hole for hinge pin which was drilled to 3mm diameter. I hot glued the base of the hinges into place. The gear that opens and closes the lid must mesh for it to work again.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
