Thingiverse
Automatic Turtle/Fish Feeder Version 4
von SuperBearFur
23
Downloads
23
Likes
0
Makes
This is another design of a fish feeder powered by arduino. The arduino uno is a separate unit from the feeder.
All you need:
- servo
- arduino
No bearings required
Print without supports at 10% infill
PLA:
Extruder temp at 200C and bed temp at 60C
All you need:
- servo
- arduino
No bearings required
Print without supports at 10% infill
PLA:
Extruder temp at 200C and bed temp at 60C
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
