Thingiverse
Backbone iPhone Controller Case - Remix
door awhyte23
6
Downloads
10
Likes
0
Makes
The original model of this case was great however, I found it a bit difficult to pull apart when I wanted to take my Backbone out of it. I made a few adjustments using Blender.
Top: I removed the lip that was created for the bottom of the case to fit into and I added holes to fit a 3x2mm magnet. (Hole size: 3.50mm x 2.1mm)
Bottom: I raised the edge that would fit within the top part of the case to level it all out and added holes to fit a 3x2mm magnet. (Hole size: 3.50mm x 2.1mm).
Top: I removed the lip that was created for the bottom of the case to fit into and I added holes to fit a 3x2mm magnet. (Hole size: 3.50mm x 2.1mm)
Bottom: I raised the edge that would fit within the top part of the case to level it all out and added holes to fit a 3x2mm magnet. (Hole size: 3.50mm x 2.1mm).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!