Backshell for 5" LCD Panel

**Notice** I need to move the four mounting holes on the rear of the backshell, as they interfere with the buttons.
**NEW**
Woops, almost forgot the button extenders! Print 5 of these; you might have to clean up the print a little; it's a tight fit.
Also, I put a 1mm fillet on the outer edges and pushed the front and back side edges of the power socket opening.
I also made a [Desktop stand for 5" LCD panel frame](http://www.thingiverse.com/thing:585577) that attaches to the back of the backshell.
**OLD**
This part goes with the [front bezel for 5" LCD display](http://www.thingiverse.com/thing:470484) that I made for a [5" HDMI (no touch) LCD panel](https://www.adafruit.com/products/1928) I got from Adafruit (they list it as a Raspberry Pi accessory). This is the back. I put 50-mm holes for mounting; you can fashion an arm or desktop stand, if you wish; I'm going to either hunt one down or make one if it doesn't already exist, and link to it here if necessary. I