Bag Rack

# Bag Rack

The Bag Rack is a 3d printable holder that can be attached to a bag to allow for convenient storage of gear/carabeeners.

[More expensive canyoneering / rope bags](https://www.outnback.com/shop/c/p/HYDRO-BAG-x60111251.htm) often have internal webbing for storage. Add your own storage to your existing bag.

## Installation

- [14] M3 x 6mm screws (8mm works for thicker material)
- [14] M3 bolts
- [14] M3 washers (optional)

For best rust resistance use only 'Stainless Steel' bolts/screws/washers.
Avoid Zinc/ Galvanized/ Aluminum (And never mix and match materials)


To install, print out 2 copies of the BagRack.stl (Or print 1 BagRack.stl and 7x of the BagRackBack.stl). Align on the bag, then poke a hole with an exacto knife.

### Printing

Print vertically using TPU


### Warning

Not intended to be used as an anchor point. Do not use in any situation that woul