Thingiverse
Ball and Socket
von Coder-Tronics
4.5k
Downloads
3.1k
Likes
7
Makes
I needed an adjustable mount for another project, something that will be able to hold a few hundred grams or more and take a bit of a vibration....so I came up with this design.
**The tolerances are pretty tight on this, so any part with a thread (nut and socket) I would print at 0.1mm, or increase the size of all the parts**
There is a short video showing a quick demonstration of the parts.
https://youtu.be/XHjbzKNqYlk
The ball and socket is nothing new, inspiration was taken from a Manfrotto camera mount and a cheap Ebay car windscreen mount for my phone. The ball jointed end can be easily redesigned to any length to meet your needs, but I have included a few variations and this is the same for the socket and ball combination.
The socket is sized to 15.3mm in diameter and the ball to 15mm, there is also a small ridge in the socket that gives a satisfying click when the ball is inserted. The shaft diameter is 8mm in all cases, this can be increased or decreased dependin
**The tolerances are pretty tight on this, so any part with a thread (nut and socket) I would print at 0.1mm, or increase the size of all the parts**
There is a short video showing a quick demonstration of the parts.
https://youtu.be/XHjbzKNqYlk
The ball and socket is nothing new, inspiration was taken from a Manfrotto camera mount and a cheap Ebay car windscreen mount for my phone. The ball jointed end can be easily redesigned to any length to meet your needs, but I have included a few variations and this is the same for the socket and ball combination.
The socket is sized to 15.3mm in diameter and the ball to 15mm, there is also a small ridge in the socket that gives a satisfying click when the ball is inserted. The shaft diameter is 8mm in all cases, this can be increased or decreased dependin
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
