Thingiverse
Ball and Socket
por Coder-Tronics
4.5k
Descargas
3.1k
Likes
7
Makes
I needed an adjustable mount for another project, something that will be able to hold a few hundred grams or more and take a bit of a vibration....so I came up with this design.
**The tolerances are pretty tight on this, so any part with a thread (nut and socket) I would print at 0.1mm, or increase the size of all the parts**
There is a short video showing a quick demonstration of the parts.
https://youtu.be/XHjbzKNqYlk
The ball and socket is nothing new, inspiration was taken from a Manfrotto camera mount and a cheap Ebay car windscreen mount for my phone. The ball jointed end can be easily redesigned to any length to meet your needs, but I have included a few variations and this is the same for the socket and ball combination.
The socket is sized to 15.3mm in diameter and the ball to 15mm, there is also a small ridge in the socket that gives a satisfying click when the ball is inserted. The shaft diameter is 8mm in all cases, this can be increased or decreased dependin
**The tolerances are pretty tight on this, so any part with a thread (nut and socket) I would print at 0.1mm, or increase the size of all the parts**
There is a short video showing a quick demonstration of the parts.
https://youtu.be/XHjbzKNqYlk
The ball and socket is nothing new, inspiration was taken from a Manfrotto camera mount and a cheap Ebay car windscreen mount for my phone. The ball jointed end can be easily redesigned to any length to meet your needs, but I have included a few variations and this is the same for the socket and ball combination.
The socket is sized to 15.3mm in diameter and the ball to 15mm, there is also a small ridge in the socket that gives a satisfying click when the ball is inserted. The shaft diameter is 8mm in all cases, this can be increased or decreased dependin
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
