Thingiverse
Balloon for interior
von RUBOT_3D
62
Downloads
68
Likes
0
Makes
The task was to remove the antenna wires.
At first they wanted to clean the wall as usual.
But then they figured out how to close the antenna wires and make a cool design decision.
The balloon printed in parts (cut into Netfabb), then glued, polished, painted.
The holder is mounted on the wall.
The balloon is glued to the holder.
At first they wanted to clean the wall as usual.
But then they figured out how to close the antenna wires and make a cool design decision.
The balloon printed in parts (cut into Netfabb), then glued, polished, painted.
The holder is mounted on the wall.
The balloon is glued to the holder.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!