Thingiverse
Balsa Stripper
von AeroMartin
81
Downloads
65
Likes
0
Makes
10/20/2024 Update: Added a protective guard to cover the blade, for safely store this handy tool. Check out a quick video for assembling at https://youtu.be/u935PC7Adco Enjoy!
Introduction
Balsa Stripper that cuts balsa sticks and more. Designed with precision in mind.
Calibrate flow rate, temperature, and other parameters carefully before printing.
BOM:
M3x50mm x1
M3x16mm Self-tapping x2
M3 nut x2
M3 lock nut x1 (or 2x M3 nuts)
Washer x2
Use PLA+ for all components, except the blade guard. Use flexible TPE filament to print the blade guard. 20% Infill.
Assembly Instructions
See Photo/TinkerCAD drawing or watch the YouTube video:
- Put a M3 nut in the cavity of the Knob piece. Screw in the main M3x50 screw.
- Add a washer and then slide the set though the hole of the Slider piece.
- (See photo) Add another washer then a M3 Lock nut to the main screw. (If no lock nut, you may use two M3 nuts, i.e. double nuts.) Make sure the M3x50 main screw is free to turn afterwards
-
Introduction
Balsa Stripper that cuts balsa sticks and more. Designed with precision in mind.
Calibrate flow rate, temperature, and other parameters carefully before printing.
BOM:
M3x50mm x1
M3x16mm Self-tapping x2
M3 nut x2
M3 lock nut x1 (or 2x M3 nuts)
Washer x2
Use PLA+ for all components, except the blade guard. Use flexible TPE filament to print the blade guard. 20% Infill.
Assembly Instructions
See Photo/TinkerCAD drawing or watch the YouTube video:
- Put a M3 nut in the cavity of the Knob piece. Screw in the main M3x50 screw.
- Add a washer and then slide the set though the hole of the Slider piece.
- (See photo) Add another washer then a M3 Lock nut to the main screw. (If no lock nut, you may use two M3 nuts, i.e. double nuts.) Make sure the M3x50 main screw is free to turn afterwards
-
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
