Bambu Cube connector

Ever thought of stacking up all your test Bambu Cubes that for some reason you didn't throw away? Probably not… but if you have, here is something that will prevent the tower from tipping over easily This is a very simple design. Should fit all test cubes that printed without major issues.I've printed about 30 (or was it 50?) of those for tests and only sometimes they needed a tiny use of force to be pushed in.Again.. depends on the cube :) This will fit a 30 mm x 30 mm x 30 mm Cube (Bambu Studio - right click - add primitive - bambu cube) Recommended settings: (PLA)2 wallsseam - backno supportsinfill - 5% grid (to ensure clean top layer)brim - I use it to start off my print cleanly in case there is any leftover filament that might be dragged onto a new printmake sure your print bed is clean and grease freeEnjoy! and Happy Printing! :)