Bambu Labs Top Mount Riser

After building the ultimate enclosure I decided to build the Bambu Labs top mount,on doing this I ran into a few issues.You cannot use it with the ultimate enclosure as there is not enough clearance for the locking screwremoving the cover to the enclosure is difficult as there is not enough clearance to open the 2 lower clips on spools 1 and 2I did find a mod to the locking screw where the head had been modified to a lower profile but problem 2 was still there and the screw was still difficult to turn with my fat fingers. The Riser is a single print that lifts the AMS 43mm higher solving both the above issues.you are also able to remove the AMS without removing the enclosure as access to the mounting screws is possible. Build:-Attach the riser to the AMS first using the 4 original screws.Mount in the BBL top mount and secure using 4 off M3 x12mm long Screws(they will cut their own thread on first fit)Add the enclosureNote:- Due to the height increase I never used the 2 tube guides that