Bambu Trash Can

I set out to design something that would test the print volume of the X1C, and limited myself to 250mm cubed. I still havent been able to print it at 100%, it maxes out at 97%. The cutout on the corner is defined by the tool, it's to accommodate the exclusion zone, As such, its something of an in-joke, for those in the know… I printed this a while ago, I wanted to use the Bambu silver filament to match the printer, but it wasnt available at the time. Still isn't as of a few days ago. My flush volumes were off, particualrly using white filament, but the silver should be more forgiving. Also, I suffered a power outage while printing this one, around logo level, it lasted a while, enough for the temp in the chamber to drop, so when it restarted it stepped a little. I'll print it again properly sometime. This was an early print too, I'd like to think I've learned a little in the ten months I've been using the printer.