Barend storage

*Edit 22 July 2024:* I've seen people downloading this a lot, but I'm not all that convinced it really works well. I don't even have it installed on a bike anymore. If you do actually make this, please leave a comment whether or not it's working for you.

Spring loaded barend plug for road bikes for easy access storage.

Inspired by barend storage for bike tools and tubeless tire pluggers, I wanted something that was easy to remove, but not friction fit. This uses a road bike's own handlebar tape to hold a sleeve around the bar end with unbent paperclips. The springs for the latch are cut down and rebent safety pins.

Also needed are two short M3 bolts and an M5 to hold whatever tool you want to attach to the removeable part of the bar end.

Very Important: wear eye protection when fitting the springs. They can easily fly off.

This is designed for small paper clips, about 0.85mm wire diameter. I splay them out after poking them through the sleeve so that it is harder to pull