Thingiverse
Barmin
von JAltham
14
Downloads
20
Likes
0
Makes
Handlebar mount for 25.8mm diameter handlebars. Needs four off threaded M3 inserts (ones I used are about 4.5mm OD) and four off M3 bolts.
Print with the clamping face of the Barmin flat to the bed with supports enabled. For strength I use 3 walls and 35% gyroid infill in Cura.
Print with the clamping face of the Barmin flat to the bed with supports enabled. For strength I use 3 walls and 35% gyroid infill in Cura.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
