Thingiverse
Base for Raspberry Pi
door joeyC
3
Downloads
3
Likes
0
Makes
A simple base for a Raspberry Pi3/4 computer. Has a spot for a 5V 25mm x 10mm cooling fan.
The design also includes spacers for use with a Pi proto hat. If a hat is used 3/4" 2-56 mounting bolts should be used. For just the Pi, 1/4" will work. They screw into the mounting posts, which should be tapped.
The fan can be powered right from the 5V pin, or controlled by a 2N2222 transistor using a GPIO pin. The standard Pi OS has a dt overlay for this. Just add the following to /boot/config.txt:
dtoverlay=gpio-fan,gpiopin=12,temp=52000
Any GPIO pin can be used, 12 is default
Temp is in millideg C, default is 55000
There is a 10deg C hysterisis for the fan to go off
Pin will be active high.
Use a 680ohm resistor from the GPIO to the base of the 2N2222.
The design also includes spacers for use with a Pi proto hat. If a hat is used 3/4" 2-56 mounting bolts should be used. For just the Pi, 1/4" will work. They screw into the mounting posts, which should be tapped.
The fan can be powered right from the 5V pin, or controlled by a 2N2222 transistor using a GPIO pin. The standard Pi OS has a dt overlay for this. Just add the following to /boot/config.txt:
dtoverlay=gpio-fan,gpiopin=12,temp=52000
Any GPIO pin can be used, 12 is default
Temp is in millideg C, default is 55000
There is a 10deg C hysterisis for the fan to go off
Pin will be active high.
Use a 680ohm resistor from the GPIO to the base of the 2N2222.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
