BASIC ANTENNA MOUNT
door fwdesign
1
Downloads
1
Likes
0
Makes
This is a very basic antenna tube mount to bolt onto any surface. It will accept a M3 screw of 6mm thread lenght. The antenna tube will slide into the top, there is a slot to slide the antenna wire in.
A dab of CA-glue should hold the tube in place.
For best results print at high infill and use a brim skirt.
A dab of CA-glue should hold the tube in place.
For best results print at high infill and use a brim skirt.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!