Thingiverse
Basic handle e.g. for inverted pull ups
von aldabro
1
Downloads
2
Likes
0
Makes
I mounted two of them under my desk for doing inverted pull ups.
The handle is already hollowed out, intended for 100% infill.
This way I could do a basic simulation test. The tiny yellow spots are just artifacts and nothing to worry about.
The handle is already hollowed out, intended for 100% infill.
This way I could do a basic simulation test. The tiny yellow spots are just artifacts and nothing to worry about.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!