Thingiverse
Basic Hexagon-pattern Coaster + Holder
door ginoadriano
16
Downloads
16
Likes
2
Makes
I needed a coaster to put my drink on. I used to have this piece of cardboard for it but then i spilled a drink and it got wrecked.
Decided to design myself a new coaster with a basic honeycomb pattern.
These coasters are 82mm in diameter and 5mm tall.
From now on i'll use these to test out new filament instead of wasting the material on printing makercoins.
I've printed them out in 0.2mm height with a 0.4 nozzle in PETG but also in PLA with a 0.6 nozzle and 0.3 layer height. I've found the 0.3 layer height to give a better finish to these coasters.
Decided to design myself a new coaster with a basic honeycomb pattern.
These coasters are 82mm in diameter and 5mm tall.
From now on i'll use these to test out new filament instead of wasting the material on printing makercoins.
I've printed them out in 0.2mm height with a 0.4 nozzle in PETG but also in PLA with a 0.6 nozzle and 0.3 layer height. I've found the 0.3 layer height to give a better finish to these coasters.
ginoadriano publiceert ook op
34 extra modellen op 3 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
