Basic Knife Holder V2

Remixed from Nightdre4mer 's design which I have used for over a year.

Features

Added a few angled surfaces (to allow water to flow off)
Added more fillets
Added a model with a cutout to add your own top design for your knives. (I kept it to a simple rectangle block so it is easy to draw)
As you can see from the photos, I have printed V2.0 only. I have created V2.1 with slightly more angled surfaces, but I don't want to print it again because V2.0 works well for me.

I also did not print out and verify the no top versions as I do not foresee any significant issues.

The cutout for the top block is 104 x 62 x 12.5mm. I have included a blank top template for reference which is slightly smaller (for clearance). Take note to anticipate bridging sag and try to do a smaller width (60mm) to avoid that.

Your mileage will vary because of different printers' capabilities. The worst case would be to do some filing I guess. ;)


*****

Want to buy me a coffee?
https://www.