Thingiverse
Basic Sandpaper Stick
door Greihart
2
Downloads
0
Likes
0
Makes
Basic Sandpaper Stick.
Cura Slicer estimates about 51 minutes to print.
I needed a simple sandpaper stick, so I made this. It has a slot to put the edge of a piece of sandpaper into, then you wrap it around the stick, and you have a sanding block.
Possible improvements could be the width of the slot to fit the sandpaper. It may be a little loose-fitting right now (I haven't noticed any issues, however).
Cura Slicer estimates about 51 minutes to print.
I needed a simple sandpaper stick, so I made this. It has a slot to put the edge of a piece of sandpaper into, then you wrap it around the stick, and you have a sanding block.
Possible improvements could be the width of the slot to fit the sandpaper. It may be a little loose-fitting right now (I haven't noticed any issues, however).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!