Thingiverse
Basic Small Go-Pro Magnet Base
von leetneko
15
Downloads
6
Likes
0
Makes
I needed a mount to attach a gopro to my 3d printer's frame.
The base takes basic 10mm neodymium magnets.
3x3 matrix of alternating poles will give the strongest mount, but i found that i only needed 4; one in each corner.
The base takes basic 10mm neodymium magnets.
3x3 matrix of alternating poles will give the strongest mount, but i found that i only needed 4; one in each corner.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
