Thingiverse
Bastard2
von bajotaz
4
Downloads
2
Likes
0
Makes
My ongoing design test of boat hulls.
No design for water proof lid so far.
Recommend water approved glue
Print layer @ 0,05.
Infill @ 25%
Support (Tree enabled) @ 8% (please fiddle with that.)
Suitable for small ponds or pools if not scaled up considerably
380 motor with 3s is overkill, yet very funny.
No design for water proof lid so far.
Recommend water approved glue
Print layer @ 0,05.
Infill @ 25%
Support (Tree enabled) @ 8% (please fiddle with that.)
Suitable for small ponds or pools if not scaled up considerably
380 motor with 3s is overkill, yet very funny.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
