Bat Clock 37cm

The diameter of this dark wall clock is 48 cm. It consists of 6 segments and a two-piece center, all of which can be printed on Ender 3 sized bed.

It is compatible with Euroshaft high torque mechanisms for 6 mm thick front plate. If you buy the hands instead of printing them, the minute hand should be appr. 15 cm long. If you print the included hands, note that the fitting is tight, so you may need to carefully enlarge the holes of the hands. If the minute hand feels too thick, you can carefully widen its hole on the underside or print a thinner hand by sinking it 0.2 mm below the bed in the slicer.

Note: If necessary, use the spacer under the clock mechanism nut. Scale its height according to your need.

All segments require supports. I printed the parts in PLA with 0.2mm layers, 3 walls, 4 bottom and 5 top layers, expect the center, where I used 2 walls. To keep the consumption of the material low, I used the following support settings in CURA: 16% zigzag infill, 2 infill steps, 2