Thingiverse
Bath Panel Clip
door Jurasik
0
Downloads
0
Likes
0
Makes
This is a clip which is designed to hold a plastic bath panel onto a fibreglass bath.
The plastic bath panel is usually loose to the underside of the bath, causing it to rattle or flap about.
This holds it in place.
There are two lengths, 150mm & 170mm.
These should work with most panels.
The smaller clips snap into place once the overall clip is placed over the edge of the panel.
You may need to trim the connecting piece off the end in order to get the clip to fit.
The plastic bath panel is usually loose to the underside of the bath, causing it to rattle or flap about.
This holds it in place.
There are two lengths, 150mm & 170mm.
These should work with most panels.
The smaller clips snap into place once the overall clip is placed over the edge of the panel.
You may need to trim the connecting piece off the end in order to get the clip to fit.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
