Thingiverse
Bath Soap Holder V2
von ugurbu
1
Downloads
2
Likes
0
Makes
I have smoothed and made more strong one via Fusion 360.
It is for 25 mm diameter.
I located large hole so you can push the sticked soap below with your finger. So big soaps are no longer problem to take out.
Start printing very slow for small hexagonal holes.
2 bolts and nuts are required to assemble it.
Have fun !
It is for 25 mm diameter.
I located large hole so you can push the sticked soap below with your finger. So big soaps are no longer problem to take out.
Start printing very slow for small hexagonal holes.
2 bolts and nuts are required to assemble it.
Have fun !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
