Thingiverse
Bathroom storage system
von Wiesolator
20
Downloads
30
Likes
0
Makes
I designed this bathroom storage system for the usual things next to the sink.
It has drawers as well as compartments for all common spray cans and storage containers.
The parts are connected with small clips. The lower part is simply put together and glued to the upper part.
The modules have a footprint of 215x215mm. With the box together it is exactly 70cm wide in four modules.
Slicer-Settings:
- Filament: PLA white
- Infill: 15% / honeycomb
- Shells (outside bottom top): 3/3/5
- Layer: 0,15mm
- No Supports
All 14 parts have a printing time of 80 hours on my printer at 300mm/s. The weight is 2,5kg.
It has drawers as well as compartments for all common spray cans and storage containers.
The parts are connected with small clips. The lower part is simply put together and glued to the upper part.
The modules have a footprint of 215x215mm. With the box together it is exactly 70cm wide in four modules.
Slicer-Settings:
- Filament: PLA white
- Infill: 15% / honeycomb
- Shells (outside bottom top): 3/3/5
- Layer: 0,15mm
- No Supports
All 14 parts have a printing time of 80 hours on my printer at 300mm/s. The weight is 2,5kg.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
