Thingiverse
Batman Toothpaste Squeezer
51
Downloads
49
Likes
1
Makes
Batman Toothpaste Squeezer
It's a simple design, made in Fusion 360, just a Batman logo with a 1mm gap in the middle, for insert the toothpaste tube into.
No supports needed, with the print settings listed below, it takes around 50 minutes to print.
Thanks for your comments
It's a simple design, made in Fusion 360, just a Batman logo with a 1mm gap in the middle, for insert the toothpaste tube into.
No supports needed, with the print settings listed below, it takes around 50 minutes to print.
Thanks for your comments
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
