Thingiverse
Battery Holder Stackable
von Chunimon
369
Downloads
270
Likes
3
Makes
Hello,
Since other models require additional gluing for stacking, I have adapted the model so that it is now stackable. There is no need for an additional botton plate.
I printed it with a layer height of 0.2 mm and with support (but only from the botton) and 0% infill. The material I used was PLA.
Since other models require additional gluing for stacking, I have adapted the model so that it is now stackable. There is no need for an additional botton plate.
I printed it with a layer height of 0.2 mm and with support (but only from the botton) and 0% infill. The material I used was PLA.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
