Battery powered IR Head Tracker – 3D printable model from MakerWorld

MakerWorld

Electronics

Battery powered IR Head Tracker

by BigPP · Electronics

16 Downloads

4 Likes

7 Makes

Go to Model

AA Battery powered version of a Track IR Clip.The switch is superglued to the frame.Materials required:-Wire-switch (clip off one of the contacts on the side)-30 Ohm resistor (yours depends the voltage of your LEDs. check out an online resistorcalculator for parallel circuit LEDs)-IR LEDs of your choice. (mine are 1,5V 20mA)-velcro for the back or some rubber bands to attach it to your headset

dcs dcs world diy headtracker headtracker track ir open track joystick flightsim head tracking flight controller flight simulator headtracking

Category

Electronics

Source

MakerWorld

Published

24.07.2025

Updated

30.04.2026

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format

STL

Material

Software

Cura, PrusaSlicer, or similar

No ratings yet

No comments yet – be the first!

Similar Models

6 Suggestions

Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee

DE EN FR ES IT NL