Thingiverse
Battery powered IR Head Tracker
by GoodestGoyim
4
Downloads
4
Likes
0
Makes
AA Battery powered version of a Track IR Clip.
The switch is superglued to the frame.
Materials required:
-Wire
-switch (clip off one of the contacts on the side)
-30 Ohm resistor (yours depends the voltage of your LEDs. check out an online resistor
calculator for parallel circuit LEDs)
-IR LEDs of your choice. (mine are 1,5V 20mA)
The switch is superglued to the frame.
Materials required:
-Wire
-switch (clip off one of the contacts on the side)
-30 Ohm resistor (yours depends the voltage of your LEDs. check out an online resistor
calculator for parallel circuit LEDs)
-IR LEDs of your choice. (mine are 1,5V 20mA)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
