Slicer Discord
battletank – 3D-printbaar model van MakerWorld MakerWorld
Robotics

battletank

door FINCH666 · Robotics
0 Downloads
1 Likes
0 Makes
Model downloaden
Summarybattletank, based on the miniplan tanks, but with a esp32 mini, steering through Dabble (bluetooth) and tires instead of tracks. Program is attached. I made two of them (different turret, different color).Parts:esp32 miniL293d motordriver icN20 motors (used 150 rpm here)DFplayer miniminiature speakerL7805 voltage regulatorcommon cathode RGB ledmini servoany IR receiverIR ledBrick tiresaxle adapters (https://nl.aliexpress.com/item/1005005339860882.html)7.4 V li-ion batterysome capacitors and resistors (Voltage regulator and LED)2n3904 transistor to amplify IR signal (see schematics)10K resistor to pullup GPIO35 on the esp32a small on/off switchpower inlet (battery charge)epoxy glue to secure the motors and batteryhotglue to secure wiringa little piece of felt (on of those self-adhesive furniture thingys)Attention points:a lot of wiring in a cramped place, so keep your wires as thin and short as possible.it is advised to work out the wiring in advance, mine looks a bit too much li
Categorie
Robotics
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Lijmen
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie