Slicer Discord
battletank – Modèle 3D imprimable de MakerWorld MakerWorld
Robotics

battletank

0 Téléchargements
1 Likes
0 Makes
Voir le modèle
Summarybattletank, based on the miniplan tanks, but with a esp32 mini, steering through Dabble (bluetooth) and tires instead of tracks. Program is attached. I made two of them (different turret, different color).Parts:esp32 miniL293d motordriver icN20 motors (used 150 rpm here)DFplayer miniminiature speakerL7805 voltage regulatorcommon cathode RGB ledmini servoany IR receiverIR ledBrick tiresaxle adapters (https://nl.aliexpress.com/item/1005005339860882.html)7.4 V li-ion batterysome capacitors and resistors (Voltage regulator and LED)2n3904 transistor to amplify IR signal (see schematics)10K resistor to pullup GPIO35 on the esp32a small on/off switchpower inlet (battery charge)epoxy glue to secure the motors and batteryhotglue to secure wiringa little piece of felt (on of those self-adhesive furniture thingys)Attention points:a lot of wiring in a cramped place, so keep your wires as thin and short as possible.it is advised to work out the wiring in advance, mine looks a bit too much li
Catégorie
Robotics
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 1/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Post-traitement
Collage
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection