Thingiverse
BBT microprobe mount
von 3D-P-Hobby
0
Downloads
0
Likes
0
Makes
This is a mount for BTT microprobe for the sprite extruder on the right side.
I printed it with this orientation without support.
the offset for this mount :
copy paste theese lines in the klipper config under [probe]
x_offset: 28.111
y_offset: 0
The original one was for the CRTouch and this a remix from rsheasby on printables
I printed it with this orientation without support.
the offset for this mount :
copy paste theese lines in the klipper config under [probe]
x_offset: 28.111
y_offset: 0
The original one was for the CRTouch and this a remix from rsheasby on printables
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
