Thingiverse
BCN3D+ HD
door altrome
25
Downloads
36
Likes
0
Makes
This thing treats to suppress completely the undesired Z wobble effect in my BCN3D+. After try some setups without success, I decided to improve the Z axis with leadscrew M8x1,5 rods. The results are excellent!! never before I got the fine results achieved with this improvement.
enjoy & share your results !!!
NOTICE: The optimal layer height for the Z-axis, changes with this new Leadscrew pitch (1.5). Check the optimal layer height in http://prusaprinters.org/calculator/#steppermotors in the "Optimal layer height" paragraph. You only need to enter the desired height and Leadscrew pitch and you will see the optimal layer value. i.e. for 0.2 the optimal layer is 0.195.
enjoy & share your results !!!
NOTICE: The optimal layer height for the Z-axis, changes with this new Leadscrew pitch (1.5). Check the optimal layer height in http://prusaprinters.org/calculator/#steppermotors in the "Optimal layer height" paragraph. You only need to enter the desired height and Leadscrew pitch and you will see the optimal layer value. i.e. for 0.2 the optimal layer is 0.195.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
