Thingiverse
bearings
por sciencetech3d
0
Descargas
2
Likes
0
Makes
Two-part bearings - one inner ring and one outer ring, internally with V-shaped grooves between the rings and a small gap(0.3mm) between the groove faces.
One 5mm ID x 11mm OD x 5mm H
One 7mm ID x 14mm OD x 7mm H
One 10mm ID x 22mm OD x 16mm H
Some effort may be required to loosen the parts.
- may try using a nail puncher to knock on the bearing face
- may try using tighten two nuts on the bearing faces and turning it loose.
One 5mm ID x 11mm OD x 5mm H
One 7mm ID x 14mm OD x 7mm H
One 10mm ID x 22mm OD x 16mm H
Some effort may be required to loosen the parts.
- may try using a nail puncher to knock on the bearing face
- may try using tighten two nuts on the bearing faces and turning it loose.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
