Thingiverse
bearings
0
Download
2
Likes
0
Makes
Two-part bearings - one inner ring and one outer ring, internally with V-shaped grooves between the rings and a small gap(0.3mm) between the groove faces.
One 5mm ID x 11mm OD x 5mm H
One 7mm ID x 14mm OD x 7mm H
One 10mm ID x 22mm OD x 16mm H
Some effort may be required to loosen the parts.
- may try using a nail puncher to knock on the bearing face
- may try using tighten two nuts on the bearing faces and turning it loose.
One 5mm ID x 11mm OD x 5mm H
One 7mm ID x 14mm OD x 7mm H
One 10mm ID x 22mm OD x 16mm H
Some effort may be required to loosen the parts.
- may try using a nail puncher to knock on the bearing face
- may try using tighten two nuts on the bearing faces and turning it loose.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!