Thingiverse
Bed leveling aid
door Hackens
16
Downloads
16
Likes
0
Makes
This small gear holds the hex nuts that are used to adjust bed leveling.
They allow a better grip when adjusting the bed, and prevent the nuts from rotating with vibrations.
If the hex hole is too tight for the nut, heat up the nut with a soldiering iron and push it into place (carefully). It should melt the ABS and get melted into place perfectly. Let it cool before touching it ! Also a standard soldiering iron (~300°C) is good for ABS but might be too hot for PLA.
They allow a better grip when adjusting the bed, and prevent the nuts from rotating with vibrations.
If the hex hole is too tight for the nut, heat up the nut with a soldiering iron and push it into place (carefully). It should melt the ABS and get melted into place perfectly. Let it cool before touching it ! Also a standard soldiering iron (~300°C) is good for ABS but might be too hot for PLA.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
