Bed Leveling Star

You're done with Bed Leveling Wizards, Heat-maps and Z-Probes? (but somehow your bed still isn't leveled nicely)

Alright then here is a more down-to-earth approach:

1. Print the smallest Leveling Star (100mm)---> the first one or two layers are enough while printing inspect the print:
- Where does it stick well to the bed? Where not?
- Is the first layer on some side more transparent/thinner?

===> The conclusions of course are:
- if the first layer is very transparent the bed is too high and needs to be lowerded there
- if the first layer doesn't stick to the bed at all, the bed is probably to low and needs to be raised there
- If you are clueless how to adjust: go for trial and error, change something -> checkout the effect


2. Adjust your bed heights based on your observations of the print.

3. Print the star again and check if things got better. Hopefully you see a difference to the first print and are able t