Bed_Support

Warning: this thing can only be useful for you if you can get hold of M3x80+ or M4x80+ bolts with partial thread, which proved to be not easy (for me).

Why this thing.
Ideally the bed can move a bit vertically but not sideways. I suppose the usual bed supports will do nicely, but I wondered whether some irregularities in my prints had to do with too much horizontal movement of my bed.
The little screw in part 2, which works on the not threaded part of the long bolts, can limit this movement. It should still enable easy vertical movement, of course, but only just (it’s of course the last thing one does, after mounting everything).

To have a choice I made a part 1 for a long M3 bolt and one for a long M4 one, ditto for part 2 a M2x12+ adjustment bolt (preferable) or, if you don’t have one, M3. It seems best if one uses lock nuts for these adjustment screws.
I hope the rest speaks for itself.

Because I had trouble finding those long bolts, a link to the seller I did find: ht